Intensifying Collodion Negatives A+B+C
Contains:
A - Copper sulfate solution 400 ml;
B - Potassium Bromide solution 400 ml;
C - Silver nitrate and Nitric acid solution 400 ml;
Instructions:
- Mix the solution A and B in a 1:1 ratio (bleach solution)
- Place the plate in to bleach solution so that you can track changes in the intensity of white
- Wash the plate in water for about 1 minute, then rinse in distilled water
- Place the plate in intensifying solution (solution C) for a few seconds. It works quickly. Pull the plate, wash and dry
Customers who bought this product also bought:
Aluminum Shiny Black Plates 4x5
Black aluminum shiny plate with protective film suitable for wet collodion process
Exact size: 99 x 122mm
Thickness: 0,0236inch (0,6mm)
€1.41
In Stock
Silver Bath Tank 810
Silver Bath Tank for collodion plates 8x10 inch (20x25 cm) or smaller Inside dimension: 30cm x 21,5cm x 2,2cmMaterial: container - wood, bath - glass, dipper - plexiglass
The volume of solution required for plate 8x10 inches is 1200 ml
€201.44
In Stock
- Out-of-Stock
Out-of-Stock
Developer Negative - 500ml
Developer for collodion negative.
Developer is ready to use
Contains: Ferrous sulphate, Organic acid, Ethanol, Distilled water
€20.96
In Stock
2 other products in the same category:
Bleaching bath for Collodion Negatives A+B
Contains:A - Copper sulfate solution 400 mlB - Potassium bromide solution 400 ml
€29.72
In Stock
Intensifying collodion negatives MIP
Amplifying collodion negatives.
It allows you to create negatives from ambrotypes (collodion image on glass)
Contains:A - pyrogallol, citric acid, water ... 500 ml;B - Silver nitrate, water ... 100 ml;
€43.05
In Stock
Contains:
A - Copper sulfate solution 400 ml;
B - Potassium Bromide solution 400 ml;
C - Silver nitrate and Nitric acid solution 400 ml;